Cleaning
1. Do not use regular dish soap!
Dish soap is grease-dissolving and can damage the oiled surface of the block.
Use only the surface cleaner tested and certified by us.
Important note:
Using any cleaning agent other than the recommended product voids the legal warranty.
2. Cleaning:
Rinse both sides first with cold water, then with hot water.
(prevents protein coagulation and warping).
Lightly mist both sides with the recommended surface cleaner,
Let sit for about 1 minute, then clean with a clean, lint-free wiping cloth or the included pad.
Note:
The pad lightly sands the surface. This keeps it smooth and easier to clean.
care
Oil the block as needed (in case of graying, water absorption, or small cracks)
1. Cleaning & drying
Clean the cutting board as described.
Let dry completely – store dust-free, grease-free, and dry.
2. Apply oil as needed
Shake care oil vigorously.
Apply care oil evenly to both sides.
Work in with a fine stainless steel sponge or the included pad in circular motions.
3. Let absorb
Let rest for at least 15 minutes.
Best to let dry standing on the narrow side.
4. Remove excess
Remove excess with a clean cotton cloth.
Dry polish for optimal sealing.
Drying time & conditions
8 hours at approx. 20 °C room temperature.
Relative humidity: 40–60%
(The drier the air, the better the result.)
Important:
Do not use the cutting board while drying.
The care oil may emit a slight natural odor during this time.
Care oil – Application & storage
Shelf life: 2 years in the sealed original container.
Yield: approx. 100 uses per 250 ml container.
Processing temperature: not below 16 °C.
After transport: let rest at room temperature for at least 24 hours.
Keep product closures clean.
Keep all products out of reach of children.
Stain Removal
Please wear disposable gloves!
1. Direct application
Apply stain remover undiluted. Let it absorb.
2. Enhanced effect
Soak a kitchen towel with stain remover. Place directly on the stain – shortens the exposure time and increases the cleaning effect.
3. Observe the mode of action
The stain remover dissolves the protective oil layer. Be sure to re-oil afterwards.
If necessary, repeat the process until the stain is removed.
Important, avoid contact with metals during treatment with the deep cleaner!
